Can Am Racing Tapestries
Description: The M8D was developed for the 1970 Can-Am season. The high strut-mounted rear wing of the M8B had been banned by Can-Am, so the M8D's rear wing was mounted low on fins, earning the car the nickname "Batmobile".[8] The Chevrolet V8 was again built by Bolthoff, who enlarged the engine to 7,620 cc (465 cu in). It now developed 670bhp at 6800rpm with 600 lb⋅ft (810 N⋅m) of torque
Description: The McLaren M20 was a sports prototype developed by McLaren for the 1972 season of the Canadian-American Challenge Cup. It served as a replacement for the team's M8Fs, but it later became the final Can-Am design created by McLaren before the team left the series after failing to secure the 1972 championship title.
Description: To race fans around the world, this car would go down in history as the famous #6 L&M Porsche. ... In Porsche terminology, the car's full identity was “917/10-003.” This was the first 917/10 received by Penske Racing and the car that the team intended to race in the first event at Mosport.
Can Am Est 1973 ATV Off-road T Shirt Racing Tapestry
by Vintage Band Shirts
$23 $30
Description: Chevron Cars Ltd. is an English manufacturer of racing cars, founded by Derek Bennett in 1965. Following Bennett's death in 1978, the firm has remained active in various guises. The original company's designs and name continue to be used to build replacement parts and continuation models of earlier Chevrons.
Description: Can-Am started out as a race series for group 7 sports racers with two races in Canada (Can) and four races in the United States of America (Am). The series was initially sponsored by Johnson Wax. The series was governed by rules called out under the FIA group 7 category with unrestricted engine capacity and few other technical restrictions.
Description: Chevron Cars Ltd. is an English manufacturer of racing cars, founded by Derek Bennett in 1965. Following Bennett's death in 1978, the firm has remained active in various guises. The original company's designs and name continue to be used to build replacement parts and continuation models of earlier Chevrons.
